How To Test A Relay With A Power Probe. Use the test light to probe the wire coming out of the relay. Connect the 9v dc as control voltage to the input and connect a switch to the terminal “3” and “4”.
Undoubtedly it is the most versatile and practical tool ever. If the reading is more than 5 ohms, your starter. If you do, then the no terminal reads the.
You Want To See 50.
How to test any car relay. If you do, then the no terminal reads the. This video goes over how to test a cars relay.
6.3 Types Of Relay Test.
From ignition key) 85 ground, switch circuit that controls accessory item (ie. With your multimeter, you can test the relay. I put the key in the on ( ii ) position, and took the ignition wire off from the starter, and placed the power probe on the terminal ( where the ign wire was ).
Test The Normally Open Terminal.
Relay testing hack you can do in your car. The power probe ii has an optional. The resistance between the two terminals should be very low.
Accessories Used In This Video Are The Back Probe Adapter Part #Aa6 And The 1 Foot Lea.
A multimeter — to determine if the relay has resistance, you must use a multimeter. If the buzzer rings, your exciter coil is working. If the buzzer ring then your electromagnetic coil is.
I Will Show You How To Test A 3 4 And 5 Pin Relay.
How to test the output control module driver using the power probe iv. Connect a 100w bulb at. Use the test light to probe the wire coming out of the relay.