How To Light A Water Heater With A Lighter. After the five minutes have elapsed and the gas has dispersed, turn the switch back to “on.”. Continue holding down the oven knob.
Turn the gas valve to “off.” 4. If there is air in the gas line, you might have to press the button a few times before the pilot light begins burning. Then release it slowly, and make sure the light is still lit.
Table of Contents
While Continuing To Hold Down The Control Knob Use The Piezo Lighter To Ignite The Gas.
Manual ignition involves lighting the heater with a long barbeque lighter clicking the lighter in order to keep the flame going to overcome including water that may block the intake. The thermostat has a plastic screw on it and may have the temperature showing on a dial. If your water heater will not stay lit and it is an older water heat.
Turn The Water Heat Dial To Low And The On/Off/Pilot Dial To Pilot.
Follow these steps to light a patio heater with a lighter 1. Find the gas valve on the patio heater. Adjust the water heater’s temperature setting to the lowest possible level.
Push On/Off Dial Down, And Simultaneously Use The Lighter.
This will start the flow of gas so you can light the flame. Make sure the heater is turned off and unplugged. You can keep on holding down the knob for a minute or so or as long as you see the pilot light lit.
You Can Look Through The Sight Glass At The Bottom Of The Combustion Chamber To Check To See If The Pilot Has Been Successfully Lit.
Turn the gas knob to “pilot,” press and hold it down. Press and hold the pilot button. Light the pilot light the pilot with a long match or lighter, continuing to hold down the pilot knob.
This May Take Multiple Clicks If The Pilot Has Been Out For A While And The Gas Line Is Full Of Air.
Then, turn the on/off/pilot dial downwards and push the igniter button at the same time. While still holding the gas down, light that pilot. Whatever your water heater needs may be, r.s.
